Daiwa SG17LCA Repair
Detailed Instructions for Anti-Reverse Ratchet Replacement
|
If you've got one of the new Daiwa 17's and find the clutch slips or becomes stuck you may need to replace the Anti-Reverse Ratchet. You can call, email, or write Daiwa for free replacement ratchets. The only problem is they don't tell ya how to replace them! Below is a detailed step-by-step on just how to do that. Click on the small pictures to open up a larger detailed image in a pop-up window.
|
 What you'll need:
A New Clutch Washer
10mm Wrench
Small Phillips Screwdriver
Split Ring Pliers
|
Step By Step
|
Start by removing the Handle Nut Plate Screw and the Handle Nut Plate.
|
Next using a 10mm wrench remove the Handle Nut.
|
Remove the Star Drag by spinning it counter clockwise off the Drive Shaft.
|
Make sure that you don't loose the 2 washers that will probably come off with the Star Drag.
|
Remove 7 Screws.
|
There are 3 different screw types that you're going to take out. It makes re-assembly easier if you lay the screws out in the same pattern as they came out of the reel.
|
Unscrew the Clutch Lever Screw about 3/4 of a turn. DO NOT REMOVE IT!!
|
If you remove the Clutch Lever Screw this spring will pop off and you'll have a "fun" time trying to get it back into place; trust me!
|
Lift the Clutch Lever up just a bit and slide the Right Side Outer Ring off.
|
Remove the Right Side Plate, this is what you'll see.
|
Lift off and remove the Drive and Drag Gear Washer Assembly. Be very careful to keep all the washer and gears in order.
|
Remove the red Drive Shaft Washer.
|
This is the part you're going to replace, the Anti-Reverse Ratchet.
|
The old Ratchet on the Left, the new on the Right.
|
Hold back the Anti-Reverse Paw, lift off the old Anti-Reverse Ratchet and replace it with the new one. Make sure the post on the ratchet is facing down. Allow the Anti-Reverse Paw to drop back down against the new Ratchet.
|
Re-assemble the reel in the opposite order as it was disassembled in.
|
Author: Eric Z
|
More Articles
|
 |
|
